You should now have a good amount of gain and crunch. now plug guitar into channel II then turn the Channel I and Channel II volume to 10 then keep the MAster Volume to control the volume. ie you solder it where the two 68K resistors are joined together for channel 1.
then take the other end of the 1Meg resistor and solder it to the junction of the 68K input resistors of CHANNEL 1. Now take a 1 MEG resisitor and solder it to the center wiper. Go to the VOLUME II pot.unsolder the wire in the center terminal of the pot wiper.then solder this wire to GROUND, you can just solder it to the next pin on the same pot that is grounded. 022uF coupling cap.also you should use the tone stack withthe 250pF on the treble with 56K slope resistor.also use. 0022uF for coupling cap and the VOLUME I bright channel should use a. DO a swap of caps before you begin.The VOLUME II channel should use the. One wire mod: OK.here is what you need to do.
